After one week of availability of the update on the iTunes store,
here a first balance:
> 70% of users have already done the update
> Only two little issues, reported by users
> Some corrections needed for German and Spanish languages
So, this new release seems to be really a major update!
Special thank to all people that contact me,
for report the use or to suggest improvements !
Hello
When I use the program, you can not connect with the PLC, an error 1;, I would like to ask you program the default PLC address?
If you can add a PLC address input box is perfect.
China and Germany are friendly, Siemens PLC market in China accounted for more than 70%; software can add the Chinese? Thank you very much!
Thank you
Dear Zhu,
in order to comunicate with your PLC you need 1.st to connect your device on the same ethernet network, then it’s mandatory to configure the correct link parameters.
Inside link tab configure your connection and try again.
Make sure the IP is correct, and setup rack and slot according with your S7 hardware configuration.
Usually, for S7-300 PN model, rack=0 and slot=2, the port in always 102.
Let me know…